Quick Start Guide

    If the Port Stephens Development Control Plan 2025 (DCP) applies, the steps listed below set out the process to be followed:

Step 1

Refer to the reference table at the start of: 

to determine which chapters within those sections apply to the proposed development type.

Step 2

If a chapter applies, then refer to the requirements listed under that chapter. Where those requirements cannot be met, demonstrate compliance with the objectives.

Step 3

Address the relevant objectives and requirements within the Statement of Environmental Effects (SEE) that is to be provided by the applicant with the lodgement of the development application.


The DA Supporting Handbook (DASH) sets out information that is required to accompany a development application to address the relevant objectives and controls of this chapter.


This diagram illustrates the structure of this Plan and shows that the requirements and objectives listed under Section D – Specific Areas overrides those requirements and objectives listed under Section B – General Provisions and Section C – Development Types. Section A – Introduction and Section E – Schedules exist to support the interpretation of the other chapters.

Note

This Quick Start Guide is not a formal part of this Plan. The legislative interpretation of this Plan is provided under Section A – Introduction.